UNV
FAQ
Back
How to set Snapshot?
2019.06.04

Answer:

Note: This function or management page may vary with models. Please see actual Web interface for details.
Note: Only some certain models support third stream.

General Setting

1. Click Setup > Video & Audio > Snapshot.

2. Select On, and then set resolution, most large and schedule as needed. Some parameters are described in the table below.

ParameterDescription
Snapshot IntervalInterval between two snapshots. For example, with Snapshot Interval set to 1 and Number of Snapshot set to 2, the camera will take 2 snapshots (take one first and then take another after 1 second).
Number to SnapshotCurrently 1, 2, and 3 snapshots are allowed.
Snapshot ModeSchedule: You need to set a snapshot time, e.g., 19:12:00, which means the camera takes a snapshot at 19:12:00.
Repeat: Allows you to set an interval (unit: sec). For example, according to the settings shown in the figure above, 60 seconds must elapse before the camera takes another two snapshots.
Event: Snapshot is triggered by an event such as an alarm input and a motion detection alarm. Settings effective to event-triggered snapshot also apply to manual snapshot.

3. Click Save.

Advanced Settings – Set clarity of snapshot

Note: Please turn off the Face Detection before setting the photo parameter.

1. Click Setup > Intelligent > Advanced Settings. Click Photo parameters tab.

2. Set the thumbnail image clarity.
3. Click Save.

 

TAGS:
Snapshot Interval, snapshot mode, clarity of snapshot, thumbnail image clarity

Inquire Now