UNV
FAQ
Back
How to set Wiper Control?
2019.06.04

Answer:

Set wiper parameters before you can control the wiper.

Note: Note: Only some certain models support this function. Please see the actual model for details.

1. Click Setup > System > Ports & Devices, and then click the External Device tab.

 

2. Set control mode for the wiper. The following table describes some major parameters.

ParameterDescription
Serial PortThe wiper is controlled by PELCO-D instructions; therefore, the PTZ protocol should be set to PELCO-D. See PTZ control for details.
Alarm Input/OutputUse alarm input and output to open or close the circuit and control the wiper.
Inquire Now